sandy_RE

how do i go about it?
just sand and fill the low area or sand it back and skim coat it again?...

erick31876

iTrader: (8)

Sand it , re wipe it with filler , block it , skim it with putty coat, block it with 180 grit, re primer. Hope this helps you

sandy_RE

thanks ill give it another go later on. im sick of sanding lol.

do you have any tips on getting body filler nice and flat, I always struggle to get the filler straight and flat on body lines that go 2 different ways like this??...

erick31876

iTrader: (8)

Wipe one half.of the body line at a time, I worked at a body shop for the last 8 years, and I still make a mess with it, lol. It takes practice

sandy_RE

I haven't tried that, just been wiping the whole lot and trying to sand it to shape, wich always ends up with too much filler on the body line and I end up undercutting one of the sides trying to get it flat.
ill see how I go with it tomorrow after work.

I should start a build thread to get some peoples input on the body work.

thanks for the advice.