Thanks

 

how did u add it? need more info of how things went and type of car

 

and by type i mean engine specs and intake

 

Had exact same problem. The powerfoam washes ALL the oil out of the housings=no more compression. Get some ATF in both leading sparkplug holes, should fire right up. You'll smoke like a **** and have to change plugs after, but you'll be good to go.

 

I have a 200 mile trip tomorrow and thought would be nice to work to engine a bit.

It is a 12a, I added the powerform from the carb the way discribed in the FAQ.

I do not have new plugs to change right now, I hope I am not in trouble.

Should I add some MMO to get it started?

 

just keep cranking it over worked for me. also how long did you keep it in? you can always get starting fluid once running give it some gas and get that **** out. its not going to fire right up with that **** in it it has to get burned out. you shouldnt have to get new plugs just take em out and scrub them with wire brush.

 

I took the spark plugs out, they seemed got soaked pretty bad, and I cleaned them, put them back in, and still no start, and took them out, soaked again. What should I do?

 

flooding......float could be sticking. tap the carb put some mmo in the gas tank...walmart carries it so you can get it this late at night.

 

dude, you just foamed the motor ... don't put anything in it. no MMO. no ATF. just get new plugs. crank it without the plugs for a few seconds, put them in and it should fire up.

 

Thanks!!! Everyone!!! Well, I don't know what did it but... MMO, crank W/O plugs, crank by hand, heated plugs, wirebrushed plugs, cranked finally for a long time with a very pissed-off-mood, then... miracle happened...

All I can say after a 60 mile run is "WOW", the powerform made the engine very smooth, pull hard all the way to the top, well worth the time and trouble I we t through. And especially, after all of this while driving the car, I feel so alive.

Thanks again everyone!!!

 

You don't have to get new plugs. They aren't some mysterious black boxes that can be ruined by a little oil. Just clean them with compressed air and let them dry for an hour or so.

 

One more question, should I change oil right away? I got to take my friend to the air port tomorrow, about 200 miles drive, is that ok for now?

 

How nasty/dark is the oil? Pull the dipstick and look at it under a bright light (sunlight is great if you've got some handy). Rub it between your fingers, smell it, taste it (if that's your kink) etc.

 

HeHe... Um, It got some color, but I think I am too lazy for today... maybe got it change before the trip when I wake up. Thanks man.

 

Glad you got 'er going.
I've never had a problem starting after using Power Foam.

 

So this stuff really works?

Ok now I have to look for this on the FAQ.

How does it make it run better I will go look!

 

make sure ur oil doesnt have fuel in it. Smell it and if it smells like fuel then i would change it. The fuel in oil is caused by the flooding issues

 

Yes this stuff works. The smoothness of the rotary extended over all rpms. I changed the oil this morning, and was amazed by how dirty it was considering it is 3 month old.

 

https://www.rx7club.com/showthread.p...hreadid=288612