its started
#1
Full Member
Thread Starter
Join Date: Feb 2004
Location: Tulsa
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
its started
ok so after getting my other 12a on the stand we started taking it apart well we had a hell of a time getting the fly wheel apart... we tried the puller approach and that didnt work and after about three different things we got out the cutting torch and heated the flywheel up and used pry bars to get it off and we didnt damage anything amazing huh... well I knew there was no compression on the rear rotor but after we got it apart it was bad... the housing it shot and then the front rotor was bad to. it held compression but I dont know how.. the apex seals were broke but still working some how. it was a big mess. I am going to start rebuilding it and making it a beefed up motor. I am looking for housing and rotors now. I will have pics soon of the mess that we found
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM