I wanted to post this a few days ago, but my internet at works been really screwy, but anyway.

Im about to buy a lake cities manifold that was used with a 48dhla. I havnt decided which carb im going to use yet. Can someone tell me if the ports on a 45 dcoe will match the ports on a 48 dhla? I know the bolt patterns are the same, im just not sure on the ports.


Here is a pic of the manifold:




Also if anyone has pics of your lakecities set up. Ide would sure like to see them.

-Shawn

 

after reading DriveFast7's response here about rotormotordriver's weber im thinking 48mm is the way to go. any suggestions to the 48dhla over the 48dcoe?

 

that manifold will not flow enough for a 48! that manifold was designed to work best with a 45! a 45 is more than enough for a stock port 12a! dont go to big, that will just kill all your low end and the stock ports dont flow top end anyways!!!

p/s where are you getting your weber? how much?

 

where where where where where

Where didja get the manifold?

 

He got it here:
https://www.rx7club.com/forum/showth...hreadid=163456

Gotta stay on top of the for sale forum. Good stuff all the time. I just wish I could have got the supension that Autoxr had on there back in the day. If whoever purchased it decides to not install it, they should contact me, cause I will guarantee they won't lose a penny from what they paid.

 

The guy used to run a 48dellorto, into a bridgy with that manifold. why do you think its not big enough?

I dont know where im getting the carb from. it will be a while, i need to buy other things first.