First off. YES. I have searched. For about an hour in fact. I could not find anything that benefits my question. So here goes:

Can anybody walk me through (preferably with pics) what goes where, and what can be removed with the installation of a holley 465cfm (it might matter...) carburetor? I have a ported intake to fit, MSD electronic fuel pump, and Mallory fuel pressure regulator to go with it. Except those have already been installed.

My main concern is the vacuum lines. I dont want to have any vacuum leaks, but i have done the "rats nest removal" (thanks pratch and rx7carl!) and had it run with the stock nikki carb.

Anybody help me out?

 

Keep it simple. My nikki has one throttle cable, one choke cable, fuel line and one vacuum line teed to the distributor. Capped everything else off real good Runs awesome! Better than when I had it new 20 years ago.

 

Can anybody post pics of their holley in their car???

 

WTF?! My holley isnt fitting. The damned radiator hose is in the way. Anybody else have this problem? How'd you fix it?

 

this is the 12a that was in my car before it lost an apex seal.

o well, it says i've uploaded that pic before, haven't a clue where so i can link to it so just go to my webpage to the pics of my car

 

sure, here ya go bro....



haha, i love being a smartass....

(hes my little brother, hes seen it a ton of times)


edit: dammit i can't find the pic of my engine bay, coulda swore that was the one... oh well

 

Have a look at my page I have tons of pictures.

http://members.cardomain.com/codeblue2