I decided to install my Holley Adjust-A-Jets on my Holley 650 double-pumper this morning and ran into a couple of questions. In this picture, what is the white nylon piece? I believe it is part of the vent. It'll have to be removed to install the Adjust-A-Jets...is that ok? If so, how are they removed? Well, I gave a little tug on one of them and it came out...actually, I think it broke. I didn't think I was tugging on it that hard.



In the instructions they say to install the foam insert between the metering block and the Adjust-A-Jet (for anti-sloshing), but they don't say how or where to place it. The only place that made sense is here:



Does that look right?

Thanks,
Rich

 

Yes, yes you've got it under control.

Vernon