help on removing sound/heat barrier
#1
1.3L is not that small
Thread Starter
help on removing sound/heat barrier
i am trying to get this crap off the floorboard of the car it is the black tar looking stuff that is glued like a ************ onto the chassis, i am taking it all off to inspect for rust sand down real good and repaint. is there any easy way to get this off?!?!?! i am using a screwdriver, chisel and a hammer, been going at it for the last 7 hours or so and have only done about a little under half the car, if not i guess im gonna have to have back surgery later cause im about to break. anyway thanks for the input
christopher
christopher
#3
Better, easier idea. go buy some dry ice, cheap about $10 for 20lbs. spread it around on the deadner, drink a beer, smoke a cig. move the ice away, tap it with a hammer. clean up with a broom.
#5
U sUx0rz @ THe IntaRwEB!
Join Date: Feb 2001
Location: Claysburg, PA, USA
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
If you can't find dry ice, like me, here's something that works just as well, and can get that crap off of vertical surfaces.. Go to a Lowe's, NAPA, heck, even a Wal-Mart, look for one of those Bernz-O-Matic torches. Get one and a couple bottles of MAPP gas. Also pick up a putty knife. Heat the sound deadener and scrape it off. Oh yea, try not to breathe too much of the smoke that rolls out.. it's nasty..
--Danny
--Danny
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-16-15 09:07 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM