Help Removing AC components and wiring harness
07-21-18, 01:26 PM
#1
Help Removing AC components and wiring harness
I removed my engine and transmission in preparation for painting my FB and I am struggling with the last few components in the engine bay.
How do I remove the wiring harnesses in a GSL-SE? If I climb under the dash, there doesn't appear to be a set of connectors immediately behind the firewall. The diagrams I've found make it look like a solid harness that weaves into the dash, at least on the driver's side. Is it possible to remove for painting or should I just wrap it in a trash bag and paint around it? Passenger side harness seems like a pain too.
I'm also needing to remove my AC components but I'm not sure how to store the parts and block off the AC ports at the firewall so that I don't get moisture in the parts. It's possible that these could sit for a while. Any advice? Anyone know what type of plugs I need and where I could get them?
How do I remove the wiring harnesses in a GSL-SE? If I climb under the dash, there doesn't appear to be a set of connectors immediately behind the firewall. The diagrams I've found make it look like a solid harness that weaves into the dash, at least on the driver's side. Is it possible to remove for painting or should I just wrap it in a trash bag and paint around it? Passenger side harness seems like a pain too.
I'm also needing to remove my AC components but I'm not sure how to store the parts and block off the AC ports at the firewall so that I don't get moisture in the parts. It's possible that these could sit for a while. Any advice? Anyone know what type of plugs I need and where I could get them?
Thread
Thread Starter
Forum
Replies
Last Post
RX-7tII88
2nd Generation Specific (1986-1992)
11
07-24-10 04:59 PM
vtecgsr95
3rd Generation Specific (1993-2002)
6
03-05-06 08:43 AM
lemonade
1st Generation Specific (1979-1985)
14
08-22-04 07:17 PM