1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

gauges not working

Thread Tools
 
Search this Thread
 
Old Dec 22, 2007 | 06:40 PM
  #1  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
gauges not working

hey guys i have the car running good but the only gauge that works is the fuel gauge. Any ideas why the others are not all fuses are good and the cables on the back are plugged in nice a tight with dielectric grease on them. any suggestions on what to cheek next. thank you
Reply
Old Dec 22, 2007 | 07:23 PM
  #2  
trochoid's Avatar
Old Fart Young at Heart
Tenured Member 10 Years
iTrader: (6)
 
Joined: Apr 2004
Posts: 15,145
Likes: 8
From: St Joe MO
When the meter fuse blows, evething except the tach and speedo quit. Since you have 1 working gauge, it's either the senders, wiring, connector at the back of the instument cluster, or the gauges themselves.
Reply
Old Dec 22, 2007 | 08:27 PM
  #3  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
ok the volt meter in the speedometer works some times and the speedometer worked the day i bought the car. what should i check and were is it. thank you
Reply
Old Dec 22, 2007 | 08:45 PM
  #4  
trochoid's Avatar
Old Fart Young at Heart
Tenured Member 10 Years
iTrader: (6)
 
Joined: Apr 2004
Posts: 15,145
Likes: 8
From: St Joe MO
Well, your profile says you have a 1997 Rx7, I'm not sure if I can provide any tech help on that new of a model.

Are you sure the connections are clean at the senders and the wires are good? An intermittant voltmeter may indicate a charging or connection problem with the alternator, which could affect the gauges. Other than that, I listed most everythng to check other than how to determine if the gauges themselves are good, which requires cluster removal.

Fwiw, the speedo is mechanical, not affected by electrics and the tach gets it's signal from the trailing coil, assuming you have an electronic dizzy.
Reply
Old Dec 22, 2007 | 09:03 PM
  #5  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
my bad it is a 79 sorry i fixed it
Reply
Old Dec 22, 2007 | 09:16 PM
  #6  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
how do you cheek the sender. via pin out to test it with a multimeter.
Reply
Old Dec 22, 2007 | 09:16 PM
  #7  
djessence's Avatar
djessence
 
Joined: Aug 2007
Posts: 2,063
Likes: 0
From: Alberta, Canada
what did you do to fix it? i have a similar issue so what was wrong with it?
Reply
Old Dec 22, 2007 | 09:16 PM
  #8  
djessence's Avatar
djessence
 
Joined: Aug 2007
Posts: 2,063
Likes: 0
From: Alberta, Canada
oh never mind you fixed your profile....my bad
Reply
Old Dec 22, 2007 | 09:25 PM
  #9  
trochoid's Avatar
Old Fart Young at Heart
Tenured Member 10 Years
iTrader: (6)
 
Joined: Apr 2004
Posts: 15,145
Likes: 8
From: St Joe MO
The voltmeter on the 79s only work wtih the key on, engine off, after that it reads rpms for the tach. Ignore my comment about charging/electrical problems in this case. Since the 79 has no oil pressure gauge, all that's left is the temp gauge. Sender is under the oil filter with a single wire attached to it.
Reply
Old Dec 23, 2007 | 10:40 AM
  #10  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
ok there is a yellow wire that is not connected to any thing right under the coils in the fender is that the wire and where in the back coil does it go. Both coils have the came same amount and color of wires coming out of them. I found where the wire should connect under the beehive cooler i have the connector off and where should the wire go to from it. thank you
Reply
Old Dec 23, 2007 | 03:56 PM
  #11  
trochoid's Avatar
Old Fart Young at Heart
Tenured Member 10 Years
iTrader: (6)
 
Joined: Apr 2004
Posts: 15,145
Likes: 8
From: St Joe MO
Temp sender wire is yellow with a white stip. Wire under the coils is not it.
Reply
Old Dec 23, 2007 | 06:44 PM
  #12  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
ok speedo works now.
Reply
Old Dec 23, 2007 | 09:02 PM
  #13  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
ok there is no yellow wire with a white strip i can wire it to the temp sender but where do i wire it yo from there i have the connector off and have 15 ft od 14 gauge wire.
Reply
Old Dec 23, 2007 | 09:06 PM
  #14  
mikewoodkozar's Avatar
Brap, Brap, Ole!
Tenured Member 10 Years
 
Joined: Apr 2005
Posts: 1,461
Likes: 0
From: kalamazoo, mi
take some pics
Reply
Old Dec 26, 2007 | 09:47 PM
  #15  
zenn's Avatar
Thread Starter
Full Member
 
Joined: Dec 2007
Posts: 83
Likes: 0
From: houston tx
I will post pics when my girl gets back with the cammera
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
Mar 17, 2022 02:46 PM
andyvideopro
General Rotary Tech Support
3
Aug 20, 2015 10:55 AM
sYnth.
Build Threads
0
Aug 19, 2015 06:27 PM




All times are GMT -5. The time now is 10:08 PM.