RX7Club.com - Mazda RX7 Forum

1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

engine swap

Thread Tools
 
Search this Thread
 
Old Jul 23, 2004 | 12:57 PM
Share
  #1  
Todd Staples's Avatar
Todd Staples
Thread Starter
"A Piece of Work"
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 319
Likes: 0
From: Rogersville, MO
engine swap
Replacing an 85 12a with an 81-82 12a 6-port. Got the clutch and flywheel thing figured out, but just wanted to check and see if I would have any problems using my original tranny with no problems. everything looks the same as the one that was on the earlier engine.
thanks,Todd
Reply
0
Old Jul 23, 2004 | 02:54 PM
Share
  #2  
Rx7carl's Avatar
Rx7carl
Airflow is my life
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 6,736
Likes: 2
From: Orlando, Fl
I think you should be fine with the transmission.
Reply
0
Old Jul 23, 2004 | 03:52 PM
Share
  #3  
Todd Staples's Avatar
Todd Staples
Thread Starter
"A Piece of Work"
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 319
Likes: 0
From: Rogersville, MO
Thanks Carl. I emailed you on another matter.
Todd
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
1jz gte vvti rx7 fc swap - drive way build
Azevedo
Other Engine Conversions - non V-8
26
Mar 1, 2019 09:19 PM
Can ungrounded wire cause the odometer not to work
maikelc
3rd Generation Specific (1993-2002)
8
Aug 24, 2015 11:04 AM
Compression test out of car
elfking
3rd Generation Specific (1993-2002)
3
Aug 19, 2015 09:48 PM
Wiring harness question
Professorpeanutrx7
New Member RX-7 Technical
5
Aug 15, 2015 01:38 PM
Back to Subforum
1st Generation Specific (1979-1985)
View Next Unread
Been Gone a while..What am i doing?




Advanced Search

All times are GMT -5. The time now is 12:11 AM.