ems for 1st gen turbo
#1
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Louisville,Ky
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
ems for 1st gen turbo
k guys, got the engine in, just need the engine managemant..... I was wondering what u guys with the swaps used to manage it...(haltech, microtech, motec, etc.).... Also what did u have to do to get it to work, as far as wiring (can you get premade wiring looms, are do u have to wire it up urself)...... Oh, and I need full enging management, not just fuel management.... Thanx
#3
8/1 Building/Drive Ratio
iTrader: (1)
haltech e6k right here.
havent installed it yet, as I am waiting to finish my fuel system.
Looked confusing at first but after reading the entire manuel and visiting hitmans website www.hitman.hm
makes sense and should go in pretty easy.
but I have a terminated kit, which makes things a lot faster.
havent installed it yet, as I am waiting to finish my fuel system.
Looked confusing at first but after reading the entire manuel and visiting hitmans website www.hitman.hm
makes sense and should go in pretty easy.
but I have a terminated kit, which makes things a lot faster.
#4
standard combustion
Join Date: Dec 2001
Location: Twin Cities Minnesota
Posts: 1,374
Likes: 0
Received 0 Likes
on
0 Posts
I Got no EMS, just plain old carburation+boostage. My EMS is a carb with variable fuel pressure referenced with boost. Works great, probably 85-95% the power of the same setup I would have with a EMS though since carbs are not as fine-tunable. But also much less money spent in the end on my setup.
Thread
Thread Starter
Forum
Replies
Last Post
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM