combination switch rebuild?
Thread Starter
Why am I doing this?
Joined: Aug 2011
Posts: 356
Likes: 1
From: GA
combination switch rebuild?
Anybody ever taken apart a combination switch and rebuilt it? I have 2 bad ones that I am thinking I can combine into one good one if I can switch stalks? Any ideas?
Joined: Mar 2001
Posts: 31,833
Likes: 3,232
From: https://www2.mazda.com/en/100th/
i have pulled a couple apart, its pretty easy. actually the switches are/were available separate if you need it.
at a minimum you should clean the contacts.
at a minimum you should clean the contacts.
Thread Starter
Why am I doing this?
Joined: Aug 2011
Posts: 356
Likes: 1
From: GA
You are right, its not too hard. Just came back in from swapping stalks to make one good switch. Just took a bit of time and studying to see how the stalks install. The electrical switches were a breeze. Cleaned what I could while I was in there, regreased the swivel points, good to go now......
Joined: Mar 2001
Posts: 31,833
Likes: 3,232
From: https://www2.mazda.com/en/100th/
You are right, its not too hard. Just came back in from swapping stalks to make one good switch. Just took a bit of time and studying to see how the stalks install. The electrical switches were a breeze. Cleaned what I could while I was in there, regreased the swivel points, good to go now......
Thread Starter
Why am I doing this?
Joined: Aug 2011
Posts: 356
Likes: 1
From: GA
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Under PSI
3rd Generation Specific (1993-2002)
19
Sep 23, 2015 11:47 PM
