I just got a full clutch cyl and slave from Mazdatrix. The SS line is male/female, but the slave cyl is a female thread. I have have not dug under the hood yet. Is there a fitting or line on the slave that the female fitting goes on? This is an 83.

 

on the slave it should be a male end. and you screw the female end of the line on to it.

 

yes, it hooks to the steel line from the clutch master cyl. it'll run along the firewall. there's a clip that holds it down. make sure you remove that before you try to take the line out.

 

Thanks guys, I did a brain fade and just looked at the parts without popping the hood. The hard line was the missing link. Worked like a charm.

 

glad to hear it worked out! hope everything goes well!