Check out my new webber from rotaryshack!
#1
Its an addiction.
Thread Starter
Join Date: May 2002
Location: Central Florida
Posts: 575
Likes: 0
Received 0 Likes
on
0 Posts
Check out my new webber from rotaryshack!
Finally it came in today!!
It's the 48DCOE
going to install it today. Im running a stock 12a with RB headers, straight pipe 2.5" with stainless steal muffler, and the GSL-SE differntial. Also installing today the direct fire kit. What kinda performance jump do you think i'll get?
It's the 48DCOE
going to install it today. Im running a stock 12a with RB headers, straight pipe 2.5" with stainless steal muffler, and the GSL-SE differntial. Also installing today the direct fire kit. What kinda performance jump do you think i'll get?
Trending Topics
#18
Senior Member
Join Date: Apr 2003
Location: Winnipeg MB
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
I was under the impression you should stick to a modified nikki or with a holly if you didnt have any porting done to your engine. does the deltro add that kind of power with out having the driveability drawbacks of the webbers?
#19
Rotary Freak
Dellortos are suposed to be more "streetable" yes.
the combo of a full exhaust and carb upgrade is what'll net you 30-40hp over STOCK. not just a carb upgrade.
the combo of a full exhaust and carb upgrade is what'll net you 30-40hp over STOCK. not just a carb upgrade.
#20
Its an addiction.
Thread Starter
Join Date: May 2002
Location: Central Florida
Posts: 575
Likes: 0
Received 0 Likes
on
0 Posts
ive got friends running the same setup, direct fire + a webber or holley with a full exhaust, rotarys like to breath, and its fa fa FAST, having posi traction helps too
#22
Hooray For Boobies!!!
Looks just like mine. Nice buy. Robs a great guy.
I have yet to get mine running. Watch your fuel pressure (4 psi, no more otherwise you may take out your needle valve) and make sure you have a good gasket between the lower intake manifold and the upper. Those are some of the issues I have just ran into when installing mine.
Good Luck.
I have yet to get mine running. Watch your fuel pressure (4 psi, no more otherwise you may take out your needle valve) and make sure you have a good gasket between the lower intake manifold and the upper. Those are some of the issues I have just ran into when installing mine.
Good Luck.
Thread
Thread Starter
Forum
Replies
Last Post
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM