Bridgeport?
Originally Posted by Kentetsu
Fuel pressure set too high?
This is one of the sweetest I've heard, and owner built too! http://media.putfile.com/short-bridge
Originally Posted by Nicholas P.
if you cant get it to idle udner 1500 rpm, and its sucking alotta gas, it just might be running really really rich......
It could be ported, but your rpm range would be higher.
It could be ported, but your rpm range would be higher.
Eats, Sleeps, Dreams Rotary
Joined: Jul 2004
Posts: 3,247
Likes: 2
From: Allentown, PA - Paterson, NJ
Back from the dead......How did you bridge-port guys use the water seals if they were cut out to match the port on the rotor housings? Jbridge is what I plan on doing.
These engines will use a bit of fuel. I have a Turbocharged 13b 929 Hiflow standard s4 turbs. Standard injectors. I had it use 1/4 of a tank in 20km. A 65litre tank. It needs a tune. I have a street port (mild). It will run at 800 fairly comfortably, but seems to really run well at 1,000rpm.
Originally Posted by Latin270
Back from the dead......How did you bridge-port guys use the water seals if they were cut out to match the port on the rotor housings? Jbridge is what I plan on doing.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM






