Rotarx7

iTrader: (3)

whos done it? ive always heard of it being done but ive never seen it. i know that its not really recommended because of their brass floats but i know the shack sells solid floats now.
i dont have my sidedraft anymore so im gonna have to work with what i have
i

Jaime Enriquez

Since you know about the shack and solid floats, it will take a high volume, low pressure pump, a Mallory or Malpassi carb/boost referenced regulator, a plenum box, big *** fuel jets....

Jimbo II

that wud be wiked. Never heard of an blowthrough IDA but never done much research into it

Hyper4mance2k

iTrader: (40)

yep there was even a kit made by HKS for a blowthrough IDA.

680RWHP12A

keepin it real i see, nice!


i believe thats the same kit seanrot had.. ran like a striped ape
the solid floats i now sell were made possible by copying his exact float after he parted the car out when he was re-stationed in japan...

the blowthrough IDA kits work great, the main problem was always the brass floats, but with the new solid floats your good to go

yetterben

ida's look BADAZZ too. Whats the deal on those rob pm me some prices!

Jaime Enriquez

The old Japanese Sigma kit worked killer with IDA's. It had a decent plenum w/ blow-off flange built in.

Try to contact rotaryengineering on the forum (Albert). He may still have one of these kits laying around...

Rotarx7

iTrader: (3)

thanx man! yeah i remember those SIGMA kits
ive got a DCOE plenum for sale. i really have no use for it anymore
anyone interested? or trade for IDA plenum? =]

mpk490p

very interesting, i have am just going IDA and was considering the blow through set up on my DCOE, but like the idea of it on the IDA
let me know if he has 2 kits!!

Mark

dbragg

iTrader: (7)

why not go IDF?

d0 Luck

real professional royce, real professional.....

Hyper4mance2k

iTrader: (40)

cause he already has an IDA...

mpk490p

i did see the idf too late now though just ordered a new 48 IDA would it cope with a street port? i may be going bridge port this year so i can always mill the 48 to 51 etc

Mark

©ØÐËߣüË

iTrader: (1)

a few pictures

680RWHP12A

hey!!! that looks like one of my setups IOTUS

Jimbo II

What kind of power could you get with a blowthrough ida setup on a 13b extend port?

680RWHP12A

with a 60mm t4 turbo 350wrhp @ 12 psi is easily achievable

Hyper4mance2k

iTrader: (40)

i'd say about 250whp non intercooled on a stock s5 turbo @10 psi

dbragg

iTrader: (7)

i wasnt being a dick. i was just putting it out there incase the OP didnt know anything about IDFs.

check before you assume

Jimbo II

Wiked. Something a bit different aye. Not many blowthrough setups gettin around down here.