Good Day All,

I am about to start my TII swap and pulled everthing off my TII car and getting ready to start on my gsl-se (pulling the engine/tranny out. I have been researching for a while now and found this info a while back and printed it, but lost it...does anyone have copies of this with pix they can email me @ demots2@hotmail.com PLEASE..

I dont have much time to be online. What i need is a good look(pix) at the se front cover with the oil line tap-in.some parties are tapping by way of drilling, some are wielding the TII drain with a short hose connection.


https://www.rx7club.com/showthread.p...les+Turbo+Swap
this post:
Work I’ve already done......

and this link///////
https://www.rx7club.com/showthread.p...bo+Swap&page=2

post =Working Dog.

 

Rex4life used the old SE wiring me i went with making my own wiring i got your pm and i dont know if you read any of my threads on the swap info that i was gathering i ll see if i can find them. myself and steve went to alot depth on my swap. i ll see what i have left

 

i stand corrected i did use some of my og wiring like my sensors for exhaust overheat, tranny , the sensor on bottom of radiator stuff like that. for the cas i made a harness with steel braid shielding 100% shielding which more then the factory.

 

i took the front cover to a welding shop and they drilled a hole in it then i put a short threaded pipe in and connected a short hose to the original connector the i had cut in half.