Back Windows
Rotary Enthusiast
Joined: Mar 2002
Posts: 822
Likes: 0
From: California
There is 1 10mm head nut on the inside, retainer clip at the point on the outside held on by a phillips head screw.
And some very strong thin wire and cut the glue between the glass and body.
I break 85% of the ones I try to take out.
John
And some very strong thin wire and cut the glue between the glass and body.
I break 85% of the ones I try to take out.
John
Burning Oil-Grinding 3rd
Joined: Apr 2002
Posts: 4,094
Likes: 1
From: Union Mills NC
Yea pull the nut and the take off the clip, Use a razor knife to cut a spot to put the wire, Last one I did, I took the Hot start assist cable appart, niped the ends and used vice grips on each end. Get some on the inside and saw back and forth. When you get to where the nut was there is a stud there. Find a way to go around it.
Senior Member
Joined: Nov 2002
Posts: 517
Likes: 0
From: NEW ZEALAND.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post