AUtometer a/f gauge on 85 12a?
#1
Junior Member
Thread Starter
Join Date: Aug 2003
Location: va
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
AUtometer a/f gauge on 85 12a?
is it possible? If so where would the wire (that goes to the o2 sensor) go? this is on an 85 gs w/12a motor. Dunno if this is possible or not
#2
Senior Member
Join Date: Oct 2002
Location: Chesapeake, Va
Posts: 432
Likes: 0
Received 0 Likes
on
0 Posts
where are you in va? In over in Norfolk most of the time. Anyways, if you really wanted to, you could weld in an 02 senor fitting to the exhaust right past the manifold, and install an o2 sensor. Wouldnt be very hard at all I would think.
#3
12A cars don't have O2 sensors stock. The best thing to do would be take your manifold to a muffler shop or something and have them drill and weld in an O2 sensor bung. It's just a nut the right size and pitch that's welded on. Then get an O2 sensor from any junkyard for a few bucks. Wideband sensors are better and pricey, but that's the cheap way.
#5
Junior Member
Thread Starter
Join Date: Aug 2003
Location: va
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Sudox_E
where are you in va? In over in Norfolk most of the time. Anyways, if you really wanted to, you could weld in an 02 senor fitting to the exhaust right past the manifold, and install an o2 sensor. Wouldnt be very hard at all I would think.
where are you in va? In over in Norfolk most of the time. Anyways, if you really wanted to, you could weld in an 02 senor fitting to the exhaust right past the manifold, and install an o2 sensor. Wouldnt be very hard at all I would think.
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM