assistance please
ok im trying to convert my doors from manual windows to power windows is there a thread already on this or can someone help me and explain what i should need and do to convert it with ease. i already have motors and regulators and switches for this to be done i just need a little guidence or a picture would greatly help of the door without the panel on it to where i can see the bolt pattern for the power windows..but like i said any assistance would be greatly apreicated and i have searched the threads for power windows and conversions so i did at least try to search for the thread if it did exist.
|
You also need 3 more short wiring harnesses. A right and left from each door motor to under the dash and a 3rd one from the main harness to the switches. It took me the longest time to figure out which harnesses they were and I had a complete harness from the same year strung 25 feet across the floor. Have an enlarged wiring diagram printed off, including all of the plug diagrams. With masking tape and a magic marker start identifying sub-harnesses and connectors. I remember lots of red and green wires in the sub-harnesses. You can dl the manuals from the following link.
http://foxed.ca/foxed/index.php?page=rx7manual Not a fun job since the radio and center console needs pulled. |
well i printed out the two main pages for the power windows it probably be better if i had like real life pictures of a car instead of a wiring diagram. and you said i needed 3 more wiring harnesses well that sucks i was hoping to just steal a few connectors off of a old car and just wire it up myself
|
First one I did was a 83 S model and the harness was in place for the window switches. I don't remember if I had to get the one from the motors to the connector harness or not?
What year was the one you did Trochoid? |
anyone have any pictures on the door with power windows in it
|
All times are GMT -5. The time now is 01:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands