http://cgi.ebay.com/ebaymotors/ws/eB...&category=6327

This street port makes 910 hp!!!
And a 9.6 1/4!!
I know 910 hp is ludricrus but aren't turbo motors low compression, so they need turbo's to make more than stock right?
anyway there's no way, even with enough n20 it wouldn't make that kinda power more than once at least.
And if you made a pass anywhere near that fast you wouldn't be able do it again without a cage, harnesses, helmet and probably a fire suit.

This isn't possible right?

 

Yeah, its been all over the forum. Its probably BS. Id like to know how hes keeping traction with those tires .

~T.J.

 

sorry, hadn't seen it yet.
he said slicks are included, but.....

 

he dosent mention an upgreaded brake set up... can you realy stop that car on a track at 155 with a stock set up?

 

if you look closely... you will see that there is NO TURBO! also, the NOS bottle is sitting in the trunk with the line coiled up at the outlet... looks to me he just set it in there to make it look like its installed...

 

FYI, he never said it was turbo'd, just that the engine was from a turbo car. So hes just running the low compression block. Still BS either way, lol.

~T.J.

 

BS, pure plain and simple.

Saw this post a while back, in the Rotary Performance section, of a car that Judge Ito built running 9.0@143mph on a bridgeported 13B plus nitrous. On a 3/4 chassis Datsun 1200, backed by a G-Force clutchless 5-speed, on Goodyear drag slicks. He said the nitrous shot was 195hp worth.

9.6@155mph on a stock chassis FB, with a J-spec production tranny? Not happening.

910hp NA + nitrous? Not happening on a 13B. R26B + nitrous I could see doing that easy. Maybe a periperhal port 20B built to the limit could manage it... but no NA + nitrous 13B in the world.

 

I don't know how he could get 900 hp out of a non-turboed 13b, even with as much nos as he is running. It sounds like bs to me too.

 

Just yesteday, it said it was doing 8 sec flat. And today, 9.6?? I say it's a high 13 sec car at best.

 

thats plain BS. i cant see 900 hp on a 13B N/A with nos maibe 450- 500 but not 900.

 

OK.. one question, The hell?

 

Yes you can stop a car at 155 with stock breaks. We do it every weekend, 83 Capri, runs 970'ish (traction probs) has just front discs (factory) and factory pads stops fine. We had a lot of problems last year gettin it to hook, 800 hp is a lot on 10" slicks at 12 psi

 

It might do 310 hp with nitrous but not 910. It's funny he has 100% seller feedback. It looks like his first negative is about to appear!

 

With english like that, I wouldn't buy anything from him if he says he built the car



JDM y0!

 

Initially the description did say it was a turbo. He changed the description after he was busted about it. (And busted about lack of cage.) Notice different color paint in engine compartment due to cheap paint job. So it has nitrous but where does the fuel come from? A "600 Halley Big Jets"? Must be some very big jets, care to do the math anyone?

 

uuuummmmmm i callll .................................................. .......BULLSHIT

everyyybody noow , one , two , three bullshit

 

uuuummmmmm i callll .................................................. .......BULLSHIT

everyyybody noow , one , two , three bullshit

 

[Car will come with copies of time slips and copies of dyno sheets. Car ran best time 9.6 Seconds @ 155Mph.]

I wanna see!

 

good point, why doesn't he post those time slips and dyno sheets on the auction.... that'd help us believe that a shot of nitrous on a low-compression built 13B with a holley carb can run 9.6 seconds in the 1/4 mile

 

Lets see, he says it uses a J-Spec 13b twin turbo engine. Now why in the hell would you lower compression on an NA engine? Normally you raise the compression. Whats with the nitrous. I would like to see the 700 hp shot of nitrous that would be needed to reach 910 hp. But wait, theres more. He says street port. That engine might make 200hp without nos. You would need at least a 20B p-port to reach 450 hp without a turbo. Someone should ask where the car redlines at. With the power he says its making, it would make that at someware around 8500-10000rpm. Someone correct me if I'm wrong about any information posted here.

 

i laughed when i saw this:

"Houses and Heads New"

 

I'm sure the 500! shot of NOS will definitly take out the floor board... some people

 

yup, make no mistake, we have a genuine moron trying to sell something. and c'mon, an engine and trans with 30 miles that have been raced. what an idiot. i wouldn't expect the engine to last very long. seriously, that car looks worked.

 

what he didn't say is those are the 1/8mi times ;p

 

Oh hey, now he says 410hp all motor. Uh... huh. Right. On a street port. Sure.