Im doin a 13b 6 port swap. I just bougth 13b 6 port headers and I already have a powerpulse muffler for my 12a engine.

1]What other components do i need to complete my exhaust for this swap? I know i need to make it straight but how?


2] I replaced my gaugse cluster recently and when i took the tseering wheel off a little 2 inch pin fell out that had a small spring on it. I think it is for the horn because now my horn will not work.

Does anyone know where it goes?

 

Hayes manual is your best bet but the 6 port there are several ongoing post use the seach and put in TII swap or something like your find it.

 

After your presilencer, you need a straight pipe that you could get anywhere, then a muffler. Perhaps even another presilencer in between. The entire setup will have to be custom.

As far as the pin/spring thing, I agree with thekyl, Haynes manual.

 

Let's see, the SE has a 6-port 13B, you're installing a 6-port 13B. Do we all suppose that maybe they will take the same exhaust system, even maybe the RB one?

Spring goes between the steering wheel and horn button.

 

I completely blanked on the SE. Thats quite a lot better of advice than the advice I gave, lol.

 

Occam's razor.

 

thanks trochoid. smartass. oh well rather you give me **** an dhelp me out, then me wing it and lose money on shipping and ****.