680RWHP12A how would you config a
10-03-03, 06:06 PM
#1
680RWHP12A how would you config a
You seem to be the resident turbo guy.
How would you configure a 48 IDA for a turbo set up. The engine will be a stock port being changed to a street port in a year or so.
Venturi- size
Fuel Jet- #
air jet- #
Emulsion tube
needle Valve- #
Thanks,
Sean
How would you configure a 48 IDA for a turbo set up. The engine will be a stock port being changed to a street port in a year or so.
Venturi- size
Fuel Jet- #
air jet- #
Emulsion tube
needle Valve- #
Thanks,
Sean
10-03-03, 06:16 PM
#2
Banned. I got OWNED!!!
on a stock motor with a small turbo i would go with
Venturi- size..... 36 or 38 mm
Fuel Jet- # .......180
air jet- #.............160
Emulsion tube.......F11 or F16
needle Valve- #...........300
also on IDA carbs the floats are brass so you need to drill a small hole and fill it with that expanding foam, then solder ou the hole. if you don't do this the float will crush with boost....
***** this a good baseline to start and you will need to fine tune it depending on your alt. and weather
Venturi- size..... 36 or 38 mm
Fuel Jet- # .......180
air jet- #.............160
Emulsion tube.......F11 or F16
needle Valve- #...........300
also on IDA carbs the floats are brass so you need to drill a small hole and fill it with that expanding foam, then solder ou the hole. if you don't do this the float will crush with boost....
***** this a good baseline to start and you will need to fine tune it depending on your alt. and weather
Thread
Thread Starter
Forum
Replies
Last Post