I searched but didn't see anything specific to this, sorry if it's a repost.

So I just picked up a "pair" of Mazda Efini Emblems from a source in Japan. However, both have the same pin configuration, which doesn't match the US rear pin config. I was wondering if these are both the front? I don't have a stock front bumper so I don't know what it's pin config is. Pics included (sorry cell phone quality). Can somone confirm if the JDM rear emblem should match the US pin config?

 

The previous owner of my car just cut the pins off and glued it on. My bumper is 99spec. The Flying M logo matches up to the holes in my bumper though.

 

Thanks, that's what I figured I would have to do. But before I started cutting I wanted to make sure I didn't get two of the fronts, and there actually be a correct fitting rear emblem. Appreciate the response.

 

That's an odd emblem, I have a stack of efini emblems and all of them have pins that match properly and are painted to match. Yours look like they're cut out to allow the paint below to show through, which is a great idea for cars that aren't factory colored.

 

Those emblems came on more than the FD. Ive seen them on an MPV looking van, too. You probably dont have FD emblems.