2gcdfis
#1
2gcdfis
Gonna be hooking up my 2nd Gen coil today and just want to make sure I took my notes correct.... In the Archives under "EASY 2nd gen direct fire install - 20 minutes" by Metallic Rock it says "9. connect leading wires to the 2nd gen coil, then to the leading plugs. Move your trailing wires to the leading position on the dizzy"
Do REALLY move my trailing wires to the leading spot on the dizzy?
I don't want to F this up so I figure I'll take my beating as a newb and ask the stupid question, rather than mess it up.
Thanks
Do REALLY move my trailing wires to the leading spot on the dizzy?
I don't want to F this up so I figure I'll take my beating as a newb and ask the stupid question, rather than mess it up.
Thanks
#3
Not really following you Jeff?
I'm asking the question because I don't know the answer....It's written up this way, so I figure it's correct (or at least been corrected). I'd rather not do this twice..Seem a little counter intuative, but hey I am a newb.
I'm asking the question because I don't know the answer....It's written up this way, so I figure it's correct (or at least been corrected). I'd rather not do this twice..Seem a little counter intuative, but hey I am a newb.
#5
Lapping = Fapping
iTrader: (13)
Why does it seem counter intuitive to move the trailing wires over to the better voltage path? It seemed totally intuitive to me, that's why I did it and told everyone about it way back then.
So act like a tennis shoe, and just do it. (Just Do It was Nike's slogan in the late 80s).
So act like a tennis shoe, and just do it. (Just Do It was Nike's slogan in the late 80s).
Thread
Thread Starter
Forum
Replies
Last Post
gsl-se addict
1st Generation Specific (1979-1985)
58
09-01-12 04:46 PM