1st gen tranny swap
1st gen tranny swap
OLDROTA
Joined: Apr 2003
Posts: 1,389
Likes: 2
From: Los Angeles
...good question. For one thing...the clutch hydraulic system is different...the T/O bearing mechanism is different. You would need the Flywheel/clutch/pp, etc from the FD....plus making sure the rear counter weight is correct for balance...
...unless you're planning over 300HP from your 12A, the '84-85 GSL-SE trans is fine. Much easier install....less $$ by far too!
...unless you're planning over 300HP from your 12A, the '84-85 GSL-SE trans is fine. Much easier install....less $$ by far too!
Full Member
Joined: Nov 2002
Posts: 190
Likes: 0
From: Grand Junction Colorado
With work probably. I dont know for sure. BUT I have heard of FD guys swaping in TII trans. I figured that because you can easily make a TII trans fit a FB that an FD trans can be made ti fit?
Thanks for all the feed back my fellow rotorheads, but now I have purchased the entire 93 engine,ecu and tranny for my 85 gsl and hopefully that will put a little more pep in my step. thanks again
Thread
Thread Starter
Forum
Replies
Last Post
Boriquaguerrero
2nd Generation Specific (1986-1992)
20
Apr 22, 2019 01:15 PM