im looking for an adapter plate to put the 12a intake manifold to a 6 port motor

can anyone make one or have one possibly?

 

i think www.tweakit.net makes one. If not there, you can have machine shops make one up for around 100-150$$

 

I used to have one but now I cant find it. Try powerhouse engineering except last time I checked, he was out. $150.

 

why aould you want one? wouldn't a s4 lower and RB upper flow better anyway...

 

wanting a niki on a 6 port? I do.

 

I know a guy who had a Nikki on a GSL-SE engine in his REPU. It had what looked like most of a 12A manifold and some areas where it'd been welded on. It's been a few years since I saw it so I can't give any details.

 

Curious, what are you up to? Rx7doctor

 

well my new car the engine has a blown coolant seal (i knew that when i bought it) so i want to put my -se motor in and carb it for a while till i get the nerve to **** with putting the EGI back on, cause with that i have to take the gastanks, fuel lines, pump, ecu harnesses etc...

 

aaahhhhh hhhaaaa makes sence.