1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

12a to 13b swap

Thread Tools
 
Search this Thread
 
Old Jun 8, 2008 | 04:45 PM
  #1  
boostedHULK's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (1)
 
Joined: Aug 2005
Posts: 255
Likes: 0
From: north california
12a to 13b swap

so i'm looking and i see some differences...most of it is the emissions stuff that's been removed already from this 13b. i've still been unable to locate the previous owner or the shop/person who built this engine. all i know is it's from the Seattle area. Anyways...i'm in the process of pulling my stuff out, and before i go too nuts with it, i'm noticing a lot more "stuff" on my harness than was on the other car and i dunno if it was removed or just had less stuff. my car is a '79 the car i got the engine from was an '83. What do i need to be looking for in the ignition stuff? i kept all the ignition pieces out of the other car, and my engine is just now being pulled, so anything i need to snag real quick? anything i need to make sure i do or have to get this ignition working?
Reply
Old Jun 8, 2008 | 07:40 PM
  #2  
rotarymaniac's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 49
Likes: 0
From: canada
if your swapping a 13b from a first gen to a 12a first gen all you'll have to worry about is the wiring. But if you have both cars just swap everything over. Leave the drivers harness (controls the lights, signals, horn etc) alone and swap the passenger harness over for the motor as you will also need the ecu for the 13b. On a side note was that 13b in the 83 already swapped in??? Only gsl-se's had the 13b factory and they were 84 and 85???
Reply
Old Jun 10, 2008 | 02:01 PM
  #3  
boostedHULK's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (1)
 
Joined: Aug 2005
Posts: 255
Likes: 0
From: north california
it wasn't an SE, it was swapped in, it's a carb'd 13B.
Reply
Old Jun 11, 2008 | 06:17 PM
  #4  
boostedHULK's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (1)
 
Joined: Aug 2005
Posts: 255
Likes: 0
From: north california
i'm running into some clearance issues with the shifter. i wasn't aware there were different 1st gen trans lengths. any insight would be awesome.
Reply
Old Jun 11, 2008 | 06:20 PM
  #5  
rotarymaniac's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 49
Likes: 0
From: canada
I think your going to have to cut a bigger hole for the shifter. On my swap it was basically a 13b tII to a 13b, same length and originally i used the same tranny... good luck and lets see some pics.
Reply
Old Jun 11, 2008 | 06:20 PM
  #6  
BlackWorksInc's Avatar
Wrkn Toyota, Rootn Wankel
Tenured Member 05 Years
 
Joined: Sep 2007
Posts: 1,642
Likes: 1
From: "Haystack" Hayward, CA
From what I've seen on the fourms, the SA and FB tranny have different shifter clearances. What tranny are you using?
Reply
Old Jun 11, 2008 | 06:56 PM
  #7  
boostedHULK's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (1)
 
Joined: Aug 2005
Posts: 255
Likes: 0
From: north california
thanks for the support and information, it's really appreciated. i went out and took some pix, saving them to the comp now, anyone give me a quick rundown on how to post them up?
Reply
Old Jun 12, 2008 | 01:22 PM
  #8  
rotarymaniac's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 49
Likes: 0
From: canada
put them on a photo host site, like photobucket.com or imageshack.com, then use the icon with the little mountain and yellow background when you post and a pop up will come up then you paste the location in that pop up... hope that helps
Reply
Old Jun 12, 2008 | 02:35 PM
  #9  
boostedHULK's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (1)
 
Joined: Aug 2005
Posts: 255
Likes: 0
From: north california
here are some of the pics of the main things i got off the car.
Attached Thumbnails 12a to 13b swap-l_13a3c4860b0c70c94a68358cbb7468a7.jpg   12a to 13b swap-l_2e130e03aa30d727a39b7217f6282f05.jpg   12a to 13b swap-l_92ce36eeb4b691043467ef39efa5205e.jpg  
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
sleepydogz
Old School and Other Rotary
8
Oct 4, 2015 03:46 PM
Josh83rx7
1st Generation Specific (1979-1985)
7
Sep 2, 2015 05:57 PM
Machupicchu
1st Generation Specific (1979-1985)
8
Aug 17, 2015 08:27 PM




All times are GMT -5. The time now is 11:50 AM.