RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   12a to 13b swap (https://www.rx7club.com/1st-generation-specific-1979-1985-18/12a-13b-swap-762529/)

boostedHULK 06-08-08 04:45 PM

12a to 13b swap
 
so i'm looking and i see some differences...most of it is the emissions stuff that's been removed already from this 13b. i've still been unable to locate the previous owner or the shop/person who built this engine. all i know is it's from the Seattle area. Anyways...i'm in the process of pulling my stuff out, and before i go too nuts with it, i'm noticing a lot more "stuff" on my harness than was on the other car and i dunno if it was removed or just had less stuff. my car is a '79 the car i got the engine from was an '83. What do i need to be looking for in the ignition stuff? i kept all the ignition pieces out of the other car, and my engine is just now being pulled, so anything i need to snag real quick? anything i need to make sure i do or have to get this ignition working?

rotarymaniac 06-08-08 07:40 PM

if your swapping a 13b from a first gen to a 12a first gen all you'll have to worry about is the wiring. But if you have both cars just swap everything over. Leave the drivers harness (controls the lights, signals, horn etc) alone and swap the passenger harness over for the motor as you will also need the ecu for the 13b. On a side note was that 13b in the 83 already swapped in??? Only gsl-se's had the 13b factory and they were 84 and 85???

boostedHULK 06-10-08 02:01 PM

it wasn't an SE, it was swapped in, it's a carb'd 13B.

boostedHULK 06-11-08 06:17 PM

i'm running into some clearance issues with the shifter. i wasn't aware there were different 1st gen trans lengths. any insight would be awesome.

rotarymaniac 06-11-08 06:20 PM

I think your going to have to cut a bigger hole for the shifter. On my swap it was basically a 13b tII to a 13b, same length and originally i used the same tranny... good luck and lets see some pics.

BlackWorksInc 06-11-08 06:20 PM

From what I've seen on the fourms, the SA and FB tranny have different shifter clearances. What tranny are you using?

boostedHULK 06-11-08 06:56 PM

thanks for the support and information, it's really appreciated. i went out and took some pix, saving them to the comp now, anyone give me a quick rundown on how to post them up?

rotarymaniac 06-12-08 01:22 PM

put them on a photo host site, like photobucket.com or imageshack.com, then use the icon with the little mountain and yellow background when you post and a pop up will come up then you paste the location in that pop up... hope that helps :rofl:

boostedHULK 06-12-08 02:35 PM

3 Attachment(s)
here are some of the pics of the main things i got off the car.


All times are GMT -5. The time now is 02:53 AM.


© 2024 MH Sub I, LLC dba Internet Brands