1984 Mazda Rx7 GSL-SE

I've been working on my fuel injectoinjectoot the professionally cleaned and tested.

While they were out I replaced the connector ends. I believe I reattached the new connector ends to the correct wire (there are only two).

Can I use a voltage meter to test the ends to make sure before I reinstall the injectors?

 

Looking at the 1985 wiring diagram on page B-2 for the 13B, the injector voltage wire color is BrY (Brown Yellow) for injector 1 and YR (Yellow Red) for injector 2. The ground side of both is BY (Black Yellow).

https://www.foxed.ca/rx7manual/manua...g_Diagrams.pdf