FB TurboII S366 Short Clip
#6
S366 is my Haven
Thread Starter
Trending Topics
#14
S366 is my Haven
Thread Starter
Here are a few pics of exhaust will take pic of muffler later today.
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
#16
S366 is my Haven
Thread Starter
Mild Intake and Large Exhaust Porting
Yes, Stock rear will get change to possible 8.8 if all goes well
#17
S366 is my Haven
Thread Starter
Here are the other photos, rained the day before had to give it a quick wash... lol
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
RX7Club.com - TainoCo's Album: Exhaust - Picture
#19
Shell 93
iTrader: (4)
Yep 3", custom downpipe with a Borg Warner Vband adapter. The mid pipe is a tad low, and you can drag it a little if you find a rutted out driveway however the car is also slammed on stock wheels. We will be putting bigger rubber/tires on it (255/40/17) and raising the car up around 1 1/2 inches and should have absolutely no problems then.
#22
S366 is my Haven
Thread Starter
Right now we have ground control coilovers up front and spring at rear with caster/camber plates.... We can raise the front up if needed as well with the rears
#25
S366 is my Haven
Thread Starter
Lol, thanks... Am actually finishing one up right now... Nothing special just want to share how it sounds inside and out... Will post link on this thread when done.