Engine assembly End play float
#1
Full Member
Thread Starter
Engine assembly End play float
Hey,
I took my front main pulley off and I'm concerned about the torrington bearing being crushed. I measured the float / end play with it assembled and got 0.02 inches. Also the front counter weight is pressed right against the plate and very close to the bolts. Does that mean it's all good? That tells me I'm okay? Please tell it alright from the pic and from that reading I got.
Thank you!!
the front torrington bearing looks fine. I'm worried about the rear one.
I took my front main pulley off and I'm concerned about the torrington bearing being crushed. I measured the float / end play with it assembled and got 0.02 inches. Also the front counter weight is pressed right against the plate and very close to the bolts. Does that mean it's all good? That tells me I'm okay? Please tell it alright from the pic and from that reading I got.
Thank you!!
the front torrington bearing looks fine. I'm worried about the rear one.
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,827
Received 2,595 Likes
on
1,843 Posts
See pic, you can measure it
Thread
Thread Starter
Forum
Replies
Last Post
curlybillbrosie
3rd Generation Specific (1993-2002)
8
03-21-03 09:55 PM