im tring to find any one here in houston that may have helped brad(the guy i bought my rx7 from) wire up the mega squirt set up in my 1986 rx7 with an s5 turbo motor swap...went to finally mount the ecu and found that there was some wires lose and had come out of the plug in and im not sure where they go. i tried looking at diyautotune.com since i think thats where he got the set up from, but the wires are diffrent colors then what they have listed. so im at a loss right now with my car dead in the garage tell i can figure out where the wires went lol..thanks for any help

 

Man that sucks to hear. There are a few people in the Houston RX-7 club that could help you get it wired correctly. I know Philip has a MegaSquirt, and Fred helps him from time to time. Fred is very knowlegdable and his expert advise is not to be taken for granted.

screen names:
Fred = rotarygod
Philip = philiptompkins

 

cool deal thanks for the heads up man ..i was gona try to have it fixed to night but looks like its not gona happen i have to get up tomarrow and head to a job interview if i can find a ride lol if not i guess im walking its not to far away..but yea found a few spots that where almost pulled apart so i have cut that out and im wokring on puting the harnes back together now but i might justsay screw it and order a new one.. again thanks for the heads up on who to talk to

 

hey there, just found this thread.
Anyway, yup, dom is right, Fred did your harness... and the problem with ordering a new one is they don't make one for and RX-7 that i know of, you'll probably kinda be starting over with that because you'll end up with a generic harness and have to put all your rx-7 related plugs and fuel injecotr resistors on it..... i'd say just try to fugure out where the wires go and fix that one.

 

alright thanks for the heads up on that im gona try to get this one figured out tonight ...

 

Have you tried getting in touch with Fred?

 

yup and i think i got it figured out gona be finishing up the last lil things today and see if she will run...
thanks for the heads up on who to talk to ..

 

still got a few isuess to work out but it atleast started today

 

Yea i built Phils wiring harness for his MS

 

Cool beans. Keep us updated on your quest. We are always here to help out. I've never wired up a MS but it can't be too hard right? LOL...maybe for me. But yes, keep us updated on your status.

 

got it all taken care of i think just got back from a test drive and everything seams to be runing like it should ...thanks for the help guys ..so on another note when is the next meet on the northeast side of houston???

 

The next meeting is Gabby's BBQ - 3101 N Shepherd Dr Houston, TX 77018

That is like north houston

 

cool deal im defanitly gona try to be there for that one..just hope t he car stays runing well lol..so far every thing seams to be working like it should

 

I also hope to keep everything running by then. If I make this meet, it will be the first time in over 3 years that I will attend 2 consecutive meetings arriving in Rotary Power!!!

 

nice man well i wish you luck ...i went out for a test drive a lil bit ago and ran in to a crx with some motor swap not sure what all he head all i know is i can hardly hear anything out of my left ear now ...he would not leave me alone ..didnt run him though cuz i didnt want to wast my gas ,that and i dont really want to run the car to hard tell i know i have everything dialed in just right and take it out to the track..