Helle everyone, since it is my first post here at the wolf section, Then i would like to say this forum part seems to be the best i have seen about Wolf 3d.

I own a fiat coupe 16vturbo, and have now installed a older Wolf 3D V4 on it, but i have some trouble.
I was going to use ref with sync, i have a 4 point trigger on the crank and one at the cam.. (info here) http://coupeweb.net/16vt/index.html


But if i look at my hard copy manual, then i loot likes both signal should go to pin 28-27 and pin 6 IS onlune if i want to use Coil negavtive.

But if i download the manual from Wolf http://wolfems.com/files/Installatio...457%201004.pdf

Then it say i should use the pin6 as sync ??

The other things seem like i have to use a 1K Ohm, 1/4W pull-up resistor, because it seems that it was build in my old ecu.

Regards
Kenneth

 

Another story, have some manage to upgrade the firmware self, ot is it only Wolf who do that..

 

here is the file i have used to try to start her.