Wolf 3d v4 ref and sync
Helle everyone, since it is my first post here at the wolf section, Then i would like to say this forum part seems to be the best i have seen about Wolf 3d.
I own a fiat coupe 16vturbo, and have now installed a older Wolf 3D V4 on it, but i have some trouble. I was going to use ref with sync, i have a 4 point trigger on the crank and one at the cam.. (info here) http://coupeweb.net/16vt/index.html But if i look at my hard copy manual, then i loot likes both signal should go to pin 28-27 and pin 6 IS onlune if i want to use Coil negavtive. But if i download the manual from Wolf http://wolfems.com/files/Installatio...457%201004.pdf Then it say i should use the pin6 as sync ?? The other things seem like i have to use a 1K Ohm, 1/4W pull-up resistor, because it seems that it was build in my old ecu. Regards Kenneth |
Another story, have some manage to upgrade the firmware self, ot is it only Wolf who do that..
|
1 Attachment(s)
here is the file i have used to try to start her.
|
All times are GMT -5. The time now is 01:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands