Hey guys this might have been mentioned before , but I did not see it on this thread , so here goes .I currently have the Wolf 3d 4.72 and was wondering if the maps on the V 500 could be converted to be used on my system .

I have alocal shop who just got the V500 and is going to install it on a T II car and said after his dyno he would give me a copy of the map . Of course if I wanted to use it , I would have to run the same turbo / injectors/ etc..

just wondering

 

Couldn't you just copy the cell load points etc from reading his map values into your own V4 tables?