Wolf 3D Pressure source for MAP sensor
Thread Starter
Joined: Jun 2001
Posts: 5,781
Likes: 2
From: Arkham Asylum
Pressure source for MAP sensor
Right now, I'm getting my pressure for the internal MAP sensor on my v3.1 from where the BAC used to be (see pic).
Is there a getter place to get the signal from?
Is there a getter place to get the signal from?
Full Member
Joined: Nov 2002
Posts: 172
Likes: 0
From: FL
Well you want your map to read exactley your motor is seeing, so you want to take reference as close to the block as possible.
There is the stock nipple that points towards the fire wall, on on the inside of the manifold for the fpr and now the one you've created. I'd say any would do, but if it'd make you feel better you could swap nipples (sounds kinky) with the one below it. I'd say theoretically that's the "best".
There is the stock nipple that points towards the fire wall, on on the inside of the manifold for the fpr and now the one you've created. I'd say any would do, but if it'd make you feel better you could swap nipples (sounds kinky) with the one below it. I'd say theoretically that's the "best".
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
Aug 22, 2015 05:52 PM