Ok... so with an APEXi boost valve and the wolf controller....i CANT stop the flippen boost....18.8psi...is a bit toooo much

any ideas what the frequency of the valve can be or how it can be found?

dynoing next saturday.....

I will post my map and dyno sheets shortly...

But help on the boost control is neeeded!! If anybody has any literature on it, it would be most welcome!! The AVC Boost controller manual wont go into frequencies etc... Data on the wolf controller would be appreciated...

Thanks

 

So are you using the wolf boost control or the apexi? the wolf boost control works very well, i have used it many times and is very accurate...

 

...am just using the Apexi Boost Valve....

I am not sure how to set up the valve postion table!...also boost cut is set at 16psi, and it just keeps boostin!

 

....guess i gotta wait for the dyno.....damn!! rebuilding in the process