I'm in Irvine...........that is if I can use the term "rotary specialist" real loosely


Seriously the guys at RRR are pretty good...just expensive. They quote me $250 for a used replacment front Iron........they usually go for about $25 bux

 

Puresports in Ramona!

Just downtown on 10th street.

 

damn mazda dunn is right up the street from me too!!!!

 

Went to Norman's (sidpex). Really cool guy, great work. It was rather expensive though, $330 for just the installation of sway bar mounts and a down pipe.

 

^ has never had to take off the stock pre-cat in an fd

more than i would have charged, but far from rape...it's a PITA!!

 

call 714 839-8018 rotary reliability & racing they been in service for about 25 years ask for louie he know what up with rotarys even call and ask him a question any he will not hesitate to answer or be like other shop bring it down and i will check and there goes 80 buck out your pocket he not like that alsi he has a inhouse dyno tell him cisco with the blue rx7 drift car recommended you he will hook you up

 

punctuation!!!!!!!!!!

 

like i said earlier hit up rob at rotaryshack in chatsworth

 

Can we please STICKY this REPOSTED thread, we get a new one every freaking week?

 

How much do places normally charge for a DP & sway bar mount installition? I saw the DP being installed, yeah it is a pain since you can't get to the top bolts unless you remove the airbox and lines to get to it.

 

ARM + LEG.

 

naw, i only charge a leg