i need a t2 rebuild
i need a t2 rebuild
03-16-10, 02:39 AM
#2
Technician
iTrader: (10)
Join Date: May 2007
Location: Sacramento, CA
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
I can build one for you here in Elk Grove, CA once my new shop is up and running which should be in the next few week's.
Your looking at about $1300 in just part's at the least + labor at $75 an hour.
That's for a basic core rebuild, nothing externally done to the block.
Basically a long block build with your normal build item's such as apex seals, oil control ring's and seal's, coolant seal's etc...
The cost can go up though if you need rotor or stationary gear bearing's or rotor's due to detonation damage or stationary gear's that have broken teeth. As well as rotor housing's from damage or are too worn down and iron's that are too grooved to be used.
It all depend's on the engine that you bring to me to rebuild.
PM me and we can work out the detail's.
Your looking at about $1300 in just part's at the least + labor at $75 an hour.
That's for a basic core rebuild, nothing externally done to the block.
Basically a long block build with your normal build item's such as apex seals, oil control ring's and seal's, coolant seal's etc...
The cost can go up though if you need rotor or stationary gear bearing's or rotor's due to detonation damage or stationary gear's that have broken teeth. As well as rotor housing's from damage or are too worn down and iron's that are too grooved to be used.
It all depend's on the engine that you bring to me to rebuild.
PM me and we can work out the detail's.
Thread
Thread Starter
Forum
Replies
Last Post
