socalrotor

iTrader: (1)

Swapping my t2 motor/trans into my gtu. Could use any help if your not busy. I will be at my work a few blocks from mazdatrix in signal hill, by the LB airport. I plan on starting up around 9ish tomorrow morning. I gotta pull out the na motor tranny out of the gtu. change out some turbo gaskets, swap the trannys. I got the MT t2 to na DS so I dont have to swap the rear subframe. My main goal it to get the motor tranny in and running. Then next weekend I will worry about the rear end. Thanks in advance.

Siraniko

iTrader: (13)

clap clap clap

fc pro am

iTrader: (8)

I can help.....after 6pm tho. Might b kinda dark by then..my bad.

Rotary13B1

iTrader: (8)

YOU HAVE the WHAT WACKY???!!!!!!!!

finishline

iTrader: (13)

PM'd.

MolososLotus FC3S

i would help out but im from the Valley Brah! Riverside with Anjew and Maczpayne

socalrotor

iTrader: (1)

I dont think it will all be done on Friday, the weekend I hope to get it all wrapped up. Thanks again pm's replied.

finishline

iTrader: (13)

i'll see ya after school man.

just have Oaxaca stand outside so he can open the gate.

i miss my papi. Oaxaquito misses him.

Battle Cat

iTrader: (78)

yo steve call me up and let me know wats up

socalrotor

iTrader: (1)

I will give ya a call in the morning. I hope to get it all done in one day(na motor tranny ecu out, t2 motor tranns ecu safc etc in) so the more help the better, 7club hommies.

teddyrx2

iTrader: (33)

wish i was closer...****...i wish i was in ******* la la land...the rotary community is alot ******* stronger...

socalrotor

iTrader: (1)

yeah right we will see what happends tomarow............thanks though

Battle Cat

iTrader: (78)

yea sho steve, hit me up, and ill go help you out.

socalrotor

iTrader: (1)

call me when you wake up heimi and anyone else that could help.....310-756-5481. The more help the better....thanks.

teddyrx2

iTrader: (33)

You trying to get it running this weekend or just get the swap done this weekend

socalrotor

iTrader: (1)

I have to get it running on the road, it is going to be the DD.. I dont need to do the rear sub swap, I already have a t2 tranny on the gtu, but the clutch fork is bent and it doesnt engage the clutch. I gotta pull out the na motor/ t2 trans, swap the tranny onto the t2 motor. Install both with the ecu, safc, boost controller, turbo timer, gauges, fuel pump, IP.

teddyrx2

iTrader: (33)

much luck to yah bra

AcidAngel7477

iTrader: (16)

what's the status on this?

:AA:

socalrotor

iTrader: (1)

The status is....tomorrow I hope to get it done. I need too many parts and didn't get any help so I wasn't very motivated this weekend to tear the na stuff out yet.I also want to wait so i can swap on hiemi's s5 snail and mani. BTW I found my other t2 Drive shaft if ya want it........200 for you!

finishline

iTrader: (13)

take note of that :AA:.