Keboh

Basic Kit Only- Includes...
Instructions
Engine Cradle
Crossmember Spuds
transmission crossmember (choice of C4/AOD/T5)
free shifter extension for T5 applications
(double sump Fox body oil pan is required)
w/o power steering..................................375.00
w/ power steering...................................385.00


BASIC KIT + DRIVESHAFT
Special package price
w/o power steering..................................595.00
w/ power steering...................................605.00

BASIC KIT PLUS- 2nd gen Ford
Includes...
Basic kit, rubber engine & transmission mounts
Driveshaft, Temp sender adapter bushing.
Special package deal pricing
w/o power steering..................................670.00
w/ power steering...................................680.00


DELUXE KIT (w/o AC or power steering)
includes...
Instructions
Engine Cradle and Spuds
Engine & Transmission rubber mounts
Transmission Bracket (choice if C4/AOD/T5)
Aluminum Radiator and Brackets
Temp. Sender Adapter Bushing
Tachometer re-cal (includes return shipping)
New Driveshaft w/ slip yoke........................1260.00


DELUXE KIT (with AC and power steering)
includes the above plus...
Condensor core re-location bracket set.............1320.00



Would it be totally sufficient to buy the Basic Plus kit? or will I still be lacking and in need of parts? how much better is the Deluxe Kit and is it worth spending the extra money on?

Keboh

Basically what I'm asking is do I need a new radiator for the build or will the stock one suffice? and does anyone know if there is a difference between the drive shaft in the basic opposed to the drive shaft in the deluxe kit?

darkprince134

iTrader: (5)

im doing a similar swap myself(305) and i know you check out granny's

a good link for your questions is :
v8rx7forum.com

tons of members and are all willing to help you with NO hassle,im piston-tarted(no knowedge on pistons) and i ask a lot of dumb *** question and everyone helps..


ya,so check it,theres a few hundred members and its always buisy on that board


and alot of grannys parts are a bit overpriced,and you can still use the FC radiator(depending on your engine setup) but it WILL need to be repositioned(many write ups on that as well) some people have most of the parts your looking for used and what not


take it easy




....welcome to the smarter"dark"side

Simplex Effect

Can you provide a link to where you are finding these Kits?

I am picking up an 86' 5.0 Carb most likely tomorrow and I have an 86' FC. Looking to find all those parts listed above, but haven't found a website that has them yet.

torch'd

depends on how many fab skills you possess. i swapped the v8 (305 chevy) into my 240sx without any kits. id say buy basic make anything else you need.

gammey4

Basic kit is enough, anything else he sells is just overpriced. Ive done a 5.0 aod swap into a 86, its a stupid simple and cheap swap.

slimvdub

totally agree 5.0 EFI or carb is super easy. I have had both and EFI is way better in my opinion so if you do it go efi you wont regret it. I also used a standalone harness from ebay to do mine. Got a harness and ecu for $375.00

Keboh

Thanks a lot guys, I ended up getting the basic plus kit... I have an efi 5.0 sitting in my garage waiting for a t5 to be bolted up, then it'll be thrown into the car. Once I get this project going, I'll make build thread so everyone can see what I'm up to