5.0 t5 clutch master cylinder?
Thread Starter
Junior Member
Joined: Jan 2018
Posts: 33
Likes: 0
From: long island NY
5.0 t5 clutch master cylinder?
Can anyone tell me what m/c they are using for the clutch? I am using the speedway pull slave that is a copy of the Wilwood. I think t is about 3/4 " piston diameter.
Senior Member
Joined: Oct 2014
Posts: 320
Likes: 7
From: winters, ca
Granny’s sold me a Wilwood 1” M/C. PN 260-3378. I believe I have the same slave cylinder as you. You can look back through my thread to around late summer 2017 to see if it looks the same.
I cant tell you how good it works/feels because I haven’t added fluid or drive the car yet. Someone on the thread I think recommended a 3/4”, but you’d have to look back through my thread for that too. The part does seem like good quality stuff. What you would expect from Wilwood.
Best luck.
I cant tell you how good it works/feels because I haven’t added fluid or drive the car yet. Someone on the thread I think recommended a 3/4”, but you’d have to look back through my thread for that too. The part does seem like good quality stuff. What you would expect from Wilwood.
Best luck.
Rotary Enthusiast
Joined: Jun 2013
Posts: 840
Likes: 2,410
From: Mom’s basement
I have one still in the box, pretty sure it's a 1 inch in my attic. I'll look, but BE SURE you go with the right one, because if you go to big you'll blow out the throwout bearing
from what I just googled, mine is a 3/4. their much smaller than the 1inch. works fine.
call speedway either way and take their advice
from what I just googled, mine is a 3/4. their much smaller than the 1inch. works fine.
call speedway either way and take their advice
Thread
Thread Starter
Forum
Replies
Last Post
Richard Miller
1st Generation Specific (1979-1985)
36
Mar 13, 2020 09:52 PM
simronrx7
3rd Generation Specific (1993-2002)
10
Jun 28, 2014 09:50 PM
RHDturboII
2nd Generation Specific (1986-1992)
2
Jul 23, 2004 05:52 AM