5.0 t5 clutch master cylinder?
Can anyone tell me what m/c they are using for the clutch? I am using the speedway pull slave that is a copy of the Wilwood. I think t is about 3/4 " piston diameter.
|
Granny’s sold me a Wilwood 1” M/C. PN 260-3378. I believe I have the same slave cylinder as you. You can look back through my thread to around late summer 2017 to see if it looks the same. I cant tell you how good it works/feels because I haven’t added fluid or drive the car yet. Someone on the thread I think recommended a 3/4”, but you’d have to look back through my thread for that too. The part does seem like good quality stuff. What you would expect from Wilwood. Best luck. |
I have one still in the box, pretty sure it's a 1 inch in my attic. I'll look, but BE SURE you go with the right one, because if you go to big you'll blow out the throwout bearing
from what I just googled, mine is a 3/4. their much smaller than the 1inch. works fine. call speedway either way and take their advice |
All times are GMT -5. The time now is 02:25 AM. |
© 2024 MH Sub I, LLC dba Internet Brands