Went to the Dyno the other day!
Thread Starter
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
Went to the Dyno the other day!
And I'm impressed with the numbers that I got. Only had three pulls and I didn't tune anything. Just wanted to see what I was pulling. Runs: 1. 285 2. 294 3. 294
The basics of the mods are:
RTEK 1.5
Walbro
720's + 550's
Aeromotive 13109 -6 AN lines
BNR Stage 1
Jacobs FC1000
NGK 9's all around
HKS S-AFR
Greddy FMIC
Corksport 3inch DP/MP, ebay duals 3 in 2 1/2 out
Those runs where around 10.6 PSI on a Greddy B spec 2
I'm looking forward to getting the RTEK V2.0 and 4x720's and see what that does on 12-12.5 PSI
The motor is just a stock Jspec. I was only expecting around 240 to 250
The basics of the mods are:
RTEK 1.5
Walbro
720's + 550's
Aeromotive 13109 -6 AN lines
BNR Stage 1
Jacobs FC1000
NGK 9's all around
HKS S-AFR
Greddy FMIC
Corksport 3inch DP/MP, ebay duals 3 in 2 1/2 out
Those runs where around 10.6 PSI on a Greddy B spec 2
I'm looking forward to getting the RTEK V2.0 and 4x720's and see what that does on 12-12.5 PSI
The motor is just a stock Jspec. I was only expecting around 240 to 250
Thread Starter
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
Just wanted to throw a picture up that someone took of me going to one of our meets. I thought it was a hot pic.
Last edited by Silverfc88; Oct 17, 2005 at 08:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM
Clacor
Single Turbo RX-7's
19
Sep 11, 2015 08:36 PM