This setup came off a 350z 20x10 +13 Front with Falken 452s 235/35/20
20x11 +13 Rear with Falken 452s 275/30/20 , i run rolled fenders will they fit ? thanks

 

No way.

 

Bahahaha no!

Do some research.

 

Why oh why would you attempt to install those size wheels on an FD?

 

You'll get flamed for asking this question in this forum. You're better of asking the same in Australian RX7 forums Good luck.

 

They'll fit with front frp fenders, and rear over fenders.

But 20" is too big, I think, Unless you "think" you can pull it off.

 

thx , will any after market rim in general from a 350z fit the fd ?

 

generally speaking, no.
oem wheels will fit, but anything decently wide wont work without widebody

 

all depends on offset and width.

 

Rolled, Nope. With pulled fenders, modified fender lines and camber you can make it "fit". I would do 19s or 18s anyway.

 

You might get a better response over at www.EscaladeClub.com

 

20 is too small for those high rollers. LOL

 

just to give you an idea...i had 20s on my car for a lil while, as i was doing a photoshoot for ISS Forged...we did it for ***** and giggles, but the car really drove like ****

given i'm stock bodied, but still it was a super conservative setup that was originally for an IS250

definitely go for 19inch, that way u can at least get a decently sized wheel on it and still be able to drive the car

heres what it looked like: