Does anyone know where exactly to buy the replacement Supernow Spherical Bushings (NMB Japan) from my Front LCA offset camber and caster bushings. I am looking to get 4-8 replacements. PandaRX7 posted a picture of one of the supernow sphericals in his build thread. Not sure which one exactly.



I assume the front offset LCA are the same units as each other and as all the others (front UCA, rear various). Although I don't know for sure. I don't have a press here and can't remove the spherical bushing without one. I was hoping to have the replacement Bushings on hand when I go to the shop for the press to make it one trip. If anyone knows the dimensions or the exact part number / replacement unit (I image from NMB-minebea Japan), please let me know where to get it. I've confirmed the following measurements with the bushing pressed in place in my LCA.:



W 17mm, B 14mm & O 18.9mm are good.

Without knowing more information, this is the ONLY bushing I could find the meeting the dimensions I know:
MBW14CR/MBW14VCR at eminebea here:
Spherical Bearing

Again, I NEED TO CONFIRM "Diameter" D and Case "Height" H or the exact part number for replacement and source of replacement. Also, do I get the "V Groove type" of not?

Thanks
Jake

NOTES:
Front LCA Camber: Super Now Front Lower Arm Super Camber Pillow Ball FD3S - RHDJapan
Front LCA Caster: Super Now Super Caster Pillow Ball Bearing Set FD3S - RHDJapan
Front UCA: Super Now Front Upper Arm Pillow Ball Set FD3S - RHDJapan
Rear LCA: Super Now Rear Lower Arm Super Pillow Ball Set FD3S - RHDJapan

 

SuperNow didn't make the bearing. NMR did as you can see on the bearing carrier.

Check with the US based race bearing companies like Aurora. Some links:
Rod Ends, Spherical Bearings & Bushings - Aurora Bearing Company
https://www.pegasusautoracing.com/gr...GroupID=AURORA

 

I will. Just need the spec since I don't have the bearing pressed out.

 

I actually found 4 spares in my garage. How fortunate!

D is 28mm
H is 14mm