tein ha instructions, help?
#1
Junior Member
Thread Starter
Join Date: Jul 2003
Location: vic
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
tein ha instructions, help?
i just bought some second hand tein ha's and there is no instructions, does anyone have some they could email or fax me?
as i want to install them this weekend.
please help i cant drive my car until i put them in as the gaurds keep rolling out cos the springs on it are to low.
help help help
thanks clint
shem1@optusnet.com.au
as i want to install them this weekend.
please help i cant drive my car until i put them in as the gaurds keep rolling out cos the springs on it are to low.
help help help
thanks clint
shem1@optusnet.com.au
#2
All out Track Freak!
iTrader: (263)
Join Date: Jul 2001
Location: Charlottesville VA 22901
Posts: 10,672
Received 412 Likes
on
250 Posts
Get the car up on jack stands as even as possible.
Unbolt the center bolt on each existing shock
take all the tires off
REARS: unbolt both rear sway links, unbolt the sway bar. knock the bolt through then unbolt the strut tower bar. Shocks should be ready to come out. May have to lift up slightly to get them over the knuckle on the upper arm.
FRONTS: unbolt the ABS lines from the upper arms. unbolt the upper arms. unbolt the lower shock bolt. unbolt the upper strut tower bar. may need a big screw driver or bar to nudge them out.
Have fun
PS knowing me a forgot some details so a search wouldn't hurt hehe
Unbolt the center bolt on each existing shock
take all the tires off
REARS: unbolt both rear sway links, unbolt the sway bar. knock the bolt through then unbolt the strut tower bar. Shocks should be ready to come out. May have to lift up slightly to get them over the knuckle on the upper arm.
FRONTS: unbolt the ABS lines from the upper arms. unbolt the upper arms. unbolt the lower shock bolt. unbolt the upper strut tower bar. may need a big screw driver or bar to nudge them out.
Have fun
PS knowing me a forgot some details so a search wouldn't hurt hehe
#3
RX-7 Bad Ass
iTrader: (55)
http://www.tein.com/ti/m50.html
They have the full installation manuals for all the products online.
Dale
They have the full installation manuals for all the products online.
Dale
#4
hey mate
you want to unwind the paltforms the spings seat on just use
a C spanner to unlock the botton ring and adjust from there
or if you cant get hold of a Cspanner use a hammer and chissel
Ben
edited just noticed that your form OZ check outhe Ausrotary.com
helpful peeps there
you want to unwind the paltforms the spings seat on just use
a C spanner to unlock the botton ring and adjust from there
or if you cant get hold of a Cspanner use a hammer and chissel
Ben
edited just noticed that your form OZ check outhe Ausrotary.com
helpful peeps there
Last edited by Dori FC; 10-28-05 at 06:36 AM.
Thread
Thread Starter
Forum
Replies
Last Post
edmcguirk
NE RX-7 Forum
3
05-30-18 06:50 PM