Ok guys I just replaced my front diff mount and now I try to put the subframe back into those little axles on the chassis and it wont go back on, I have been searching the forum for about 2 hours I havent found anything. I have a 88 fc convertible

 

Loosen the front diff mount. Get the subframe and rear diff on their respective mounts with the front mount loose and then tighten the front diff mount, raise the entire assembly and bolt it in.

Worst case seperate the 2. Put the diff in the car loosely on the rear mounts, then put the subframe in, and bolt them together via the front mount. Then raise the assembly into position and tighten.

 

Ok I will let you know how it goes, gonna do it right now

 

Could the diff and drive shaft get stuck? Im trying to push it up but the diff wont go up

 

I try turnung the drift shaft and it wont turn, I try jacking the diff up abd it wont go up unless the whole car goes with it

 

Yoke fell out.....