Stance coilover disassembly
#1
Stance coilover disassembly
Quick question that I can't find an answer to...
I have stance GR's. From what I've read, the spherical bearings in the upper mounts up front are shot, and creek. They need replaced.
There's a nut on top of the coilover, will that come off without the whole thing springing apart or anything? Any other tips on replacing the bearings?
I would just take it apart and figure it out, but this is a daily and it can be down no longer than one day, so I'd like to know what I'm doing before I start.
I've never taken a coilover apart, and can't find any info on it, Stance's website is a joke.
Also, any good places to get the bearings? I assume any place that sells Stance's can get the parts, I'll try calling touge factory tomorrow.
Thanks in advance.
Nate
I have stance GR's. From what I've read, the spherical bearings in the upper mounts up front are shot, and creek. They need replaced.
There's a nut on top of the coilover, will that come off without the whole thing springing apart or anything? Any other tips on replacing the bearings?
I would just take it apart and figure it out, but this is a daily and it can be down no longer than one day, so I'd like to know what I'm doing before I start.
I've never taken a coilover apart, and can't find any info on it, Stance's website is a joke.
Also, any good places to get the bearings? I assume any place that sells Stance's can get the parts, I'll try calling touge factory tomorrow.
Thanks in advance.
Nate
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM